Measuring Up Guide
Generally kitchen units stand approximately 870mm off the floor
i.e. the measurement from the floor to the underside of the worktop is approximately 870mm.
The legs are 150mm high and can be adjusted approx 10mm up or down.
Standard plinths are 150mm high and can be cut down on site to fit.

Carcasses usually measure 720 mm (870mm less 150mm) overall height and come in standard widths of 300mm, 400mm, 500mm and 600mm or multiples thereof.
Doors have a recommended gap of 2 mm on each side and 2.5mm on the top and the bottom.
The gap between two panels (door and drawer or two drawers) is usually 5mm.

You should, in any case, measure the door or drawer you are replacing. As the front edges are usually profiled you should always measured doors or drawers across their backs.

Any problems at all, please call us for advice

Hinges:
It is likely that the hinge hole positions will only need measuring for the first door but be careful to check every one.
Measure from the edge of the door to the CENTRE of the large hinge hole.